Plunge Angle Compensation
Is possible to compensate the machined profile based on tool plunge capabilities.
Sometimes you can import turning profile with pockets, by default no check are performed.
So you can have some scenario like in the image below, where the tool collide with profile.
To overcome this problem is possible to select different plunge modes.
- By Tool Geometry
- Don't Plunge
The profile are not manipulated and no check are performed , is the default mode.
By Tool Geometry
In this mode , pocketing is not enabled. The profile is compensated in this way :
Edit plunge angle
You can adjust tool orientation from tool geometry parameter.
Enable [Edit Plunge Angle] and then edit the [Additional plunge angle]